We need to know the "girth" or "circumference" of your flaccid (not erect) penis. This is measured at the mid point of the penile shaft (halfway down the shaft) and is best carried out standing up. We suggest that you use a clean piece of paper cut to about half an inch (20mm) in width or a piece of ribbon. Use a ruler or measure to find the length of the paper or ribbon. When you have done this wait for one minute and then do it again. (The length of the SenSlip is adjustable)
To select the correct size for your SenSlip measure the circumference of the penis halfway down the shaft. The measurement must be taken when the penis is flaccid, (soft not erect).
Below is a list of sizes available. Find your measurement within the circumference ranges and make a note of the size it corresponds to.
| Size |
Measurements |
| |
|
| 2 |
2 13/16” (71mm) to 2 15/16” (75mm) |
| 3 |
3” (76mm) to 3 1/8” (80mm) |
| 4 |
3 3/16” (81mm) to 3 3/8” (86mm) |
| 5 |
3 7/16” (87mm) to 3 11/16” (93mm) |
| 6 |
3 11/16” (94mm) to 3 15/16” (100mm) |
| 7 |
4” (101mm) to 4 1/4” (108mm) |
| 8 |
4 5/16” (109mm) to 4 9/16” (116mm) |
| 9 |
4 5/8” (117mm) to 4 15/16” (125mm) |
| 10 |
4 15/16” (126mm) to 5 1/4” (133mm) |
| 11 |
5 1/4” (134mm) to 5 1/2” (139mm) |
