This is the aim in wearing the Senslip and the following explains how to fit it.

Fitting & Wearing Your SenSlip

To Start: You will need to be clean dry and have some talcum (baby powder) to hand. Make sure that you have powdered the Senslip and your penis. To ensure that you are getting the most comfortable results you may have to make more than one attempt to make sure that you are getting the best and most comfortable results. When fitted correctly the Senslip should be very comfortable.

1) On opening the package you will notice that the Senslip is inside out showing the white flocked surface.

2) Insert your forefinger into the narrow coloured end of the Senslip, gently push the coloured part into the wider flocked part.

You may need to use your other hand to keep the flocked white shaft round so the artificial foreskin folds into the cavity smoothly.

3) Insert the head of the penis into the part of the Senslip.

4) When the head of the penis has been inserted into the Senslip, roll the white flocked part of the Senslip towards yourself.

5) Continue to roll the white flocked part of the Senslip towards yourself until all of the penis shaft has been covered.

"Take your time to get it right"

You can, if desired, adjust the length of the Senslip with a sharp pair of scissors. Remove the Senslip and cut off the required amount from the ribbed end to achieve the desired length.

It is strongly recommended that you wear the Senslip for just a few hours a day to start with. As you become more familiar with the product you will want to wear it all day. The Senslip should be a 'snug' fit but never too tight. If it is too tight, or causes discomfort, remove it immediately.

The Senslip is designed to stay on the penis all day, you may however find the need to make minor adjustments to it when visiting the bathroom.

Alternate Fitting Methods>>

How to care for my Senslip >>